Hubei Honest Biochemical Co., Ltd.

Company News

Steps by Steps for Making 50ml Testosterone Enanthate

Requirement:

12.5g Testosterone Enanthate "Powder"

7.5ml of Benzyl Benzoate

2.5ml of Benzyl Alcohol

29.5ml of your favourite Oil

20CC Syringe

12CC Syringe

2 18ga needles, 1 25ga Needle

45 Sterile Whatman Filter

50ml Sterile Vial

50ml Vial

Electric Scale

Rubbing Alchol / Paper Towels

1.Now that all materials are in place, take out scale and put on unsterile 50ml vial on scale and zero out.

2. Melt down the powder to a liquid to find out exactly how much displacement it takes up.

Start by Drawing up 15ml of liquid,

make sure there are no airbubbles and plunger is exactly in line with 15ml hatch mark.

Now slowly squirt test enanthate into vial until scale says 12.5 grams.

Usually exactly 12.7-12.8ml so 1g has a little more

then 1 mL displacement but for little experiments it's not gonna matter .

Also add the 7.5ml of bb and 2.5ml of ba.

3.Now add 27.5ml of the 29.5ml of oil into the vial

to make total volume of oil/ba/bb/hormone to be 50 mL.

Leave the 2ml of oil in syringe for later use.

4.Take out sterile 50ml vial and wipe stopper with rubbing alchol.

Put 18ga needle and 25ga needle through stopper,

and attach whatman filter to the 18ga needle stuck in vial

5.Open up 20ml syringe and attach 18ga needle and draw up 20ml of unfiltered gear. You will need to repeat this step another 2 times, last time only drawing up 10ml.

6.Once you've filtered all 50ml and vial is totally empty, take the last 2ml you had saved and run it through the filter to get all gear out of it and only leave plain oil in the filter.

This is what final product will look like. Notice i left 25ga pin in, there is more than 50ml in this picture,

10ml left over that i wanted to refilter from last cycle. Look at that nice golden color, compared to the amber EQ i made in last thread.

7.Now put vial in oven at 200 degrees F, and bake for 15 minutes.

Some repeat this step more than once